This manual covers several different Power Mac G5 models. Some models may look slightly different from the one shown in the illustrations; however, except where indicated, the following procedures apply to all models. 22 Power Mac G5 Take Apart. Opening the Computer. Your Power Mac G5 is designed so you can set it up quickly and start using it right away. 1 Remove any protective film from the outside of your computer and from the inside of the side panel. For instructions about opening the side panel, see “Opening the Computer” on page 44. 2 Plug the power cord firmly and completely into the recessed power cord socket on the back of the.
Are you looking for the the instruction manual of the Polar G5? View the user manual of this product directly and completely free.
Power Mac G5 Disassembly Guide
CAUTION:
Power Mac G5 Operating System
To prevent damage to the steering gear, secure it to the vise using a copper plate or clean cloth.
1. Disassemble in the order indicated in the figure.
1 | Dust cover |
2 | O-ring |
3 | Tie-rod end (See Tie-rod End Disassembly Note.) |
4 | Locknut |
5 | Boot clamp |
6 | Boot band (See Boot Band Disassembly Note .) |
7 | Boot |
8 | Tie rod (See Tie Rod Disassembly Note.) |
9 | Mounting rubber (See Mounting Rubber Disassembly Note.) |
10 | Steering gear |
Mac G5 A1047
Tie-rod End Disassembly Note
1. Place alignment marks as shown in the figure for proper installation.
2. Remove the tie-rod end.
Boot Band Disassembly Note
1. Insert a flathead screwdriver into the boot band as shown in the figure, then press the caulked area outward to remove the boot band.
Tie Rod Disassembly Note
1. Lock the steering rack end (pinion gear side) against rotation with a wrench and remove the tie rod using the suitable wrench.
Mounting Rubber Disassembly Note
1. Remove the mounting rubber from the gear housing using the SSTs
and a press.
Imac G5 Teardown
Steering Gear And Linkage Assembly
CAUTION: To prevent damage to the steering gear, secure it to the vise using a copper plate or clean cloth. 1. Assemble in the order shown in the figure. 1 ...Steering Gear And Linkage Inspection
1. Remove the steering gear and linkage.. 2. Remove the tie-rod end and boot.. 3. Measure the rotation torque of the pinion shaft using a crescent wrench and pull scale. (speed measurement refer ...Other materials:
Push Button Start Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the meter hood.. 3. While pressing the push button start tab in the direction of the arrow (1) shown in the figure, push out the push button start in the direction of the arrow (2) shown in the figure to detach the push button start tab fr ...
Refrigerant System Service Cautions
Handling Insufficient Refrigerant Level If an insufficient refrigerant level is detected at troubleshooting, do not charge (add) the refrigerant. Because an accurate amount of refrigerant cannot be determined from the pressure indicated on the manifold gauge, never charge the refrige ...
Mac G5 Specs
Hydraulic Variable Valve Timing Actuator Inspection
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. CAUTION: Do not disassemble the hydraulic variable valve timing actuator because it is a precision unit. 1. Disconnect the negative battery cable.. 2. Rem ...